The preparing work before installation related to jaw crusher can smoothly installation, even will affect the quality of the installation of the jaw crusher, so what preparation work need to do before installation? Luoyang Dahua summarized for you the following three points:
1, The basis for acceptance. For jaw crusher vibration is larger at work, the machine should be installed on the basis of concrete, and have the vibration isolation measure, in the basis of acceptance, in addition to design should be based on size and specification inspection foundation dimensions, elevation, center, the center line of the wire of the fixed signs, set aside the correctness of the anchor bolt hole position, must also test whether the foundation rigidity and bearing capacity to meet the design requirements, in order to make the second grouting layer and precast equipment foundation is firm, the combination of the base surface should also be shoveled pockmark.
2, Basic pay-off. Because the crusher and belt conveyor for two working procedure, therefore, the positioning line and installation datum line of a crusher with transportation equipment line must be followed.The first determine crusher installation position, again based on crusher determine the position of the auxiliary machine.
3, Equipment acceptance. Acceptance of the jaw crusher work, mainly is the packing list and equipment drawings, counting parts number, check the appearance quality.If there are defects, should be resolved as soon as possible, need to clean the parts and components, should be washed by the requirement, need beforehand assembly, should check the assembly dimension, assembly according to technical requirements. Have been counted, clean with good parts, according to the installation order, handling in place, near to the base for installation.
